We are looking for agents/dealers worldwide. Kindly drop us a mail for further discussions.

 Elmec speciality manifold  heaters are highly compressed and most advanced heating solution for injection manifolds. The elmecspeciality  manifold heater allows excellent heat exchange between the surfaces of heater and manifold. These heaters are installed by careful hammering on the heaters along with section grove over the manifold and pressed to hold the heaters in position and to get good surface contact, which results in good thermal exchange and increases the heater life and reduces energy loss.

 

Length

300 -1550mm

400 - 2100mm

Maximum Current

12 A

15 A

Nominal Voltage

< 230V

< 400V

Wattage

±10%

±10%

Dielectric Strength

1.5 HV

1.5 HV

Insulation MΩ

>5Ω

>5Ω

Leakage Current

<0.5 mA

<0.5 mA

Minimum Unheated

30mm

35mm

Terminal Pins

M3 x .50mm/ Plain post

M4 x .70mm

Length Tolerances: ± 2%
Diameter Tolerance: ± 0.10mm

 

 

When Ordering please Specify

  • Dia & length of the heater.
  • Watt voltage & ohm's value
  • Drawing for special type configuration.

We can manufacture and supply any intermediate diameter and length, Send drawing or sample for special size.

Top